Debugging steps of precise four column hydraulic cutting machine

Precise four column cutting machine debugging steps ready machine position, three-phase power supply anti-wear hydraulic oil (such as the the Great Wall and the Shell brand purchase) machine is placed before the rubber pad machine foot pad good backup, and fix the machine foot screws. Install two brackets. Cover with inner six angle screws knife to open the machine in the middle, anti-wear hydraulic oil. The machine electrical connection (three FireWire, a ground wire) after connection, open the power switch of the machine, open the pump switch, turn off the power switch immediately; staff face motor fan, see motor fan clockwise or counterclockwise rotation, clockwise rotation must. If the motor fan blade is counterclockwise rotation, in the case of power failure, arbitrary adjustment of the position of a firewire. The machine is preheated, the cutting depth is adjusted to a closed set switch, the setting handle is moved down to the middle position to be fixed, and the two hands are pressed by the line, and the action of the machine is preheated by a dozen. Put the plate on the work table (which can support the white board, to put on the pallet), nylon plate (plate size and the working table is as large as), situated in the middle of the plate; the knife mold plate placed between the blade down. After putting, the pallet is pushed into the working table of the machine, and the edge of the backing plate is exactly the same as the edge of the machine working table. Release the set handle (counter clockwise) and open the switch. At this time, the machine presses down the die, the backing plate and the supporting plate. Set the handle to move up and down a few, to prevent the setting down. Tighten the set handle (clockwise), turn off the switch. Pull out the pallet, put the material (waste material) on the bottom of the knife (the edge of the knife to the material), and then push the pallet into the working table. At this point, look at the depth of the cutting must be damaged otherwise the die. Hands press the top of the machine to cut the button, the line after the withdrawal of the pallet to see if the material is cut. If there is no cutting, fine-tuning the depth of cut, adjust a scale and then try to see the effect; not cut, and then adjust a scale to try again; there is a little bit off, and then adjust the scale of half cut. Only to just cut, and then adjust the half scale can be. Remember to fine tune the depth only. Warning: staff are not allowed to enter the work table at any time!